ZyXEL Communications GS2210 Series - How to Configure DHCP Auto-Configuration

51/215
www.zyxel.com
1.11 How to configure DHCP auto-configuration
The example shows how new switches are being deployed across sites
with unique configurations. A SI (System Integrator) would normally
complete this setup by restoring switch configurations before handing
over the switch to the customer. However, there is a possibility that the
restored configuration was for a different site.
With DHCP auto-configuration, the SI do not need to worry about
restoring the wrong configurations.
The switch just needs to pre-configure the DHCP auto-configuration
settings and the switch is ready to install.
Enable DHCP auto-configuration to restore configuration file from TFTP server