28/215
1.5 How to configure the switch to update the time from an
NTP server
This example shows administrators how to use the NTP server to update
the system time of the switch. As shown below, the PC connects with
Switch and Switch connects with the USG in the environment.
Set up Switch to get time from NTP Server
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using XGS4600-32 (Firmware Version: V4.50). We use google
free public NTP server (216.239.35.12) to be our NTP server. You can also choose
another available NTP server. Furthermore, due to there is routing set up in this
configuration, the user interface might be some difference for other models.
To Next Page
Loading...
