ZyXEL Communications GS2210 Series - CHAPTER 4 The Web Configurator; 4.2 System Login

34/215
www.zyxel.com
1.6.1 Configure the Switch-1
1 Enter the web GUI and go to Menu > Management > Syslog
Setup > Syslog Server Setup. Activate the syslog server setup
and set up the server IP address. In this example, it is
192.168.1.200. Choose the Log Level you prefer (Level 0-7 in
this example). The wider the range, the more detailed log will
be recorded. Remember to click “Add”.
2 In the same page, activate the Syslog and activate the
logging type you prefer. Also, remember to click “Apply”.
Note:
Log Level refers to which events should be sent to the Syslog Server.
Severity: Emergency (0), Alert (1), Critical (2), Error (3), Warning (4), Notice
(5), Informational (6), and Debug (7).