141/215
5.2 How to configure MAC filter to block unwanted traffic
The example shows administrators how to configure MAC filter to block
unwanted traffic. In this example, Switch-1 will block traffic based on
which device sends the packet or which device receives the packet.
Configure MAC filter to block unwanted traffic
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using XGS4600-32 (Firmware Version: V4.50) and GS2210-48HP
(Firmware Version: V4.30).
To Next Page
Loading...
