ZyXEL Communications GS2210 Series - Test the Result

165/215
www.zyxel.com
5.5.6 Test the Result
1 Disconnect and connect the PC with Switch. PC should show
an “Additional information is needed to connect to this
network.” pop-up message.
2 Enter the username (User-A) and password (zyxeluserA) which
must be consistent with the RADIUS-Server’s user profile
settings.
3 Devices using User-A and User-B credentials can
communicate with Private-Server.
4 Connect User-A device to the Switch. User-A should show an
“Additional information is needed to connect to this network.”
pop-up message.
5 Enter the username (Guest) and a random password.
6 Device using Guest credentials cannot communicate with
Private-Server, but it can communicate with USG.