ZyXEL Communications GS2210 Series - Configure Link Aggregation on Stacked Switch

94/215
www.zyxel.com
3.1.2 Configure Link Aggregation on Stacked switch
1 Connect to the stacked switch. Enter web GUI and go to
Menu > Advanced Application > Link Aggregation > Link
Aggregation Setting. Active T1 and T2. Select SLOT 1 and set
the Group of port 1/1 and 1/2 as T1 and T2, respectively. Click
“Apply”. Select SLOT 2 and set the Group of port 2/1 and 2/2
as T1 and T2 respectively. Click “Apply”.
2 Go to Menu > Advanced Application > Link Aggregation >
Link Aggregation Setting >LACP. Check the “Active” box, as
well as for T1 and T2.