49/215
1.10.2 Test the Result
1 In the setting, we set the IP range:
192.168.10.100-192.168.10.120, which is allowed to access the
Switch by all protocol types, EXCEPT HTTP. Therefore, if we use
PC-1 (192.168.10.100) to access the Switch by HTTP, the Switch
will refuse the connection. If we try to access the web GUI by
HTTPS (Enter the https://192.168.10.1), PC-1 can connect to the
Switch successfully.
2 The PC-2 (192.168.10.200) is not in the range which is allowed
to access the Switch. PC-2 cannot access or ping the switch’s
management IP address.
3 AdministratorPC can access the Switch by all service types
successfully.
To Next Page
Loading...
