145/215
5.3 How to configure the switch to prevent IP scanning
In this example, we will use Anti-ARP Scan to prevent attackers from identifying
all network devices in the local area network. ARP Scanning is a method by
which attackers send multiple ARP request packets in a very short period of
time to flood across the entire broadcast domain.
IP Scanning from Wired and Wireless Devices
Note:
All network IP addresses and subnet masks are used as examples in this article.
The Access Point in this section uses the default Radio and SSID Profile.
For this section, we will refer to “Zenmap” as the IP Scanning tool.
All UI displayed in this article are taken from the XGS4600 series switch.
To Next Page
Loading...
