186/215
5.9 How to configure IPSG static binding for trusted network
devices
This example will instruct the administrator on how to configure the
switch to allow an administrator device to use a static IP address on the
access port even while ARP Inspection in enabled. This allows the
administrator device more freedom and take advantage of IP-specific
policies configured on the network while non-administrative devices
must still use IP addresses offered by the real DHCP server.
Administrator Device Using a Static IP Address Connected on an Access Port
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. All
UI displayed in this article are taken from the XGS4600 series switch.
To Next Page
Loading...
