148/215
5 Access the Switch’s Web GUI. Go to Advance Application >
Anti-Arpscan > Host Status. An entry for Host-A should appear
with an “Err-Disable” state.
6 Host-B should still be able to reach the USG.
7 Connect Host-C to the Switch.
8 Host-C should perform a quick scan for IP address 192.168.1.1
to 192.168.1.100.
Note:
If Errdisable Recovery has been configured, the Host-A entry should
recover after the Errdisable Recovery Interval. Host-A will be able to
reach the USG, afterwards.
To Next Page
Loading...
