Chapter 10 Control Panel
Cloud Storage User’s Guide
110
10.4.2.1 Creating a Port Trunking
Link Aggregation: Link aggregation combines LAN1 and LAN2 into a single logical link with
greater bandwidth. Both interfaces use the same IP address and MAC address. It also includes fault
tolerance and load balancing. Connect LAN1 and LAN2 to the same Ethernet switch.
Figure 62 Link Aggregation
Use this screen to set up port trunking. Click Control Panel > Network > TCP/IP > Network
Interface, and then click Create.
Figure 63 Creating a Port Trunking
Cancel Click this to return to the previous screen without saving.
Remove Click this to remove the port trunking.
Note: This button is available only when the port trunking is created.
Table 40 Control Panel > Network > TCP/IP > Network Interface (continued)
LABEL DESCRIPTION
To Next Page
Loading...
