Chapter 10 Control Panel
Cloud Storage User’s Guide
111
The following table describes the labels in this screen.
10.4.2.2 Configuring PPPoE Settings
Use this screen to configure PPPoE settings for a direct Internet connection. Select the ppp0
interface and then click Edit.
Figure 64 Control Panel > Network > TCP/IP > Network Interface > PPPoE
The following table describes the labels in this screen.
Table 41 Control Panel > Network > TCP/IP > Network Interface > Create
LABEL DESCRIPTION
Automatically Select this option to have the interface get IP address information automatically.
If no IP address information is assigned, the NAS uses Auto-IP to assign itself an IP
address and subnet mask. For example, you could connect the NAS directly to your
computer. If the computer is also set to get an IP address automatically, the computer
and the NAS will choose addresses for themselves and be able to communicate.
Manually Select this option for the interface to use fixed TCP/IP information. You must fill in the
following fields.
IP Address - Type an IP address in this field.
Subnet Mask - Type an IP subnet mask in this field.
Default Gateway - Type a default gateway address in this field.
Create Click this to save the settings and create a port trunking.
Cancel Click this to return to the previous screen without saving.
Table 42 Control Panel > Network > TCP/IP > Network Interface > PPPoE
LABEL DESCRIPTION
Enable PPPoE to
directly connect
to the Internet
Select or clear this field to enable or disable PPPoE.
Username Enter the username exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components
exactly as given.
Password Enter the password associated with the username above.
Show password Select this field to reveal the password hidden behind asterisks or clear this field to hide
the password.
To Next Page
Loading...
