Chapter 43 Object
ZyWALL USG Series User’s Guide
844
The following table describes the labels in this screen.
43.7.2.2 IPv6 Address Add/Edit Screen
The Configuration > Object > Address/GeoIP > Address > Add/Edit screen allows you to create a new
address or edit an existing one. To access this screen, go to the Address screen (see Section 43.7.2 on
page 841), and click either the Add icon or an Edit icon in the IPv6 Address Configuration section.
Figure 584 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv6)
Table 324 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv4)
LABEL DESCRIPTION
Name Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is case-
sensitive.
Address Type Select the type of address you want to create.
Note: The Zyxel Device automatically updates address objects that are based on an
interface’s IP address, subnet, or gateway if the interface’s IP address settings
change. For example, if you change 1’s IP address, the Zyxel Device
automatically updates the corresponding interface-based, LAN subnet
address object.
IP Address This field is only available if the Address Type is HOST. This field cannot be blank. Enter the IP
address that this address object represents.
Starting IP
Address
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the
beginning of the range of IP addresses that this address object represents.
Ending IP Address This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the end
of the range of IP address that this address object represents.
Network This field is only available if the Address Type is SUBNET, in which case this field cannot be blank.
Enter the IP address of the network that this address object represents.
Netmask This field is only available if the Address Type is SUBNET, in which case this field cannot be blank.
Enter the subnet mask of the network that this address object represents. Use dotted decimal
format.
Interface If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the Address Type,
use this field to select the interface of the network that this address object represents.
Region If you selected GEOGRAPHY as the Address Type, use this field to select a country or continent.
A GEOGRAPHY object uses the data from the country-to-IP/continent-to-IP address database.
Go to the Configuration > Object > Address/Geo IP > Geo IP screen to configure the custom
country-to-IP/continent-to-IP address mappings for a GEOGRAPHY object.
FQDN If you selected FQDN as the Address Type, use this field to enter a fully qualified domain name.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
