ZyXEL Communications USG210 - Page 843

Chapter 43 Object
ZyWALL USG Series User’s Guide
843
The following table describes the labels in this screen. See Section 43.7.2.1 on page 843 for more
information as well.
43.7.2.1 IPv4 Address Add/Edit Screen
The Configuration > Object > Address/GeoIP > Address > Add/Edit screen allows you to create a new
address or edit an existing one. To access this screen, go to the Address screen (see Section 43.7.2 on
page 841), and click either the Add icon or an Edit icon in the IPv4 Address Configuration section.
Figure 583 Configuration > Object > Address/GeoIP > Address > Add/Edit (IPv4)t
Table 323 Configuration > Object > Address/Geo IP > Address
LABEL DESCRIPTION
IPv4 Address Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
References Select an entry and click References to open a screen that shows which settings use the entry.
# This field is a sequential value, and it is not associated with a specific address.
Name This field displays the configured name of each address object.
Type This field displays the type of each address object. “INTERFACE” means the object uses the
settings of one of the Zyxel Device’s interfaces.
IPv4 Address This field displays the IPv4 addresses represented by each address object. If the object’s
settings are based on one of the Zyxel Device’s interfaces, the name of the interface displays
first followed by the object’s current address settings.
Reference This displays the number of times an object reference is used in a profile.
IPv6 Address Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
References Select an entry and click References to open a screen that shows which settings use the entry.
# This field is a sequential value, and it is not associated with a specific address.
Name This field displays the configured name of each address object.
Type This field displays the type of each address object. “INTERFACE” means the object uses the
settings of one of the Zyxel Device’s interfaces.
IPv6 Address This field displays the IPv6 addresses represented by each address object. If the object’s
settings are based on one of the Zyxel Device’s interfaces, the name of the interface displays
first followed by the object’s current address settings.