Using 802.1x 75
Figure 40 Wireless Network Connection Properties Screen
3 Click the Authentication tab.
4 Verify that the Enable network access control using IEEE 802.1X check
box is selected.
5 In EAP type, verify that Smart Card or other Certificate is selected.
Configuring the Encryption Settings
By default, Windows XP automatically detects available wireless networks
and allows you to configure each network independently. Configure the
encryption settings on the wireless station to match those on the Access
Point.
802.1x networks normally use EAP-TLS. This is a dynamic key system, so
there is no need to enter key values.
To Next Page
Loading...
