22-9
To do… Use the command… Remarks
Configure the operation type operation { get | put }
Optional
By default, the operation type for
the FTP is get, that is, obtaining
files from the FTP server.
Configure a login username username name
Required
By default, no login username is
configured.
Configure a login password password password
Required
By default, no login password is
configured.
Specify a file to be transferred
between the FTP server and
the FTP client
filename file-name
Required
By default, no file is specified.
Configure common optional
parameters
See
Configuring Optional
Parameters Common to
an NQA Test Group
Optional
z When you execute the put command, a file file-name with fixed size and content is created on the
FTP server; when you execute the get command, the device does not save the files obtained from
the FTP server.
z When you execute the get command, the FTP test cannot succeed if a file named file-name does
not exist on the FTP server.
z When you execute the get command, please use a file with a smaller size as a big file may result
in test failure because of timeout, or may affect other services because of occupying too much
network bandwidth.
Configuring an HTTP Test
An HTTP test is used to test the connection between the NQA client and a specified HTTP server and
the time required to obtain data from the HTTP server, thus detecting the connectivity and performance
of the HTTP server.
Configuration prerequisites
Before performing an HTTP test, you need to configure the HTTP server.
Configuring an HTTP test
Follow these steps to configure an HTTP test:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
To Next Page
Loading...
