3Com 4510G - Displaying and Maintaining Link Aggregation

2-10
To do... Use the command... Remarks
Configure the global link
aggregation load sharing
mode
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
destination-port | ingress-port |
source-ip | source-mac |
source-port } *
Optional
By default, the hash keys
for Layer 2 packets are
source/destination MAC
addresses, and those for
Layer-3 packets are
source/destination IP
addresses.
After you configure this
command, the load
sharing modes in all link
aggregation groups
change accordingly
Configuring a load sharing mode for a link aggregation group
Follow these steps to configure a load sharing mode specific to a link aggregation group:
To do… Use the command… Remarks
Enter system view system-view —
Enter Layer 2 aggregate
interface view
interface bridge-aggregation
interface-number
—
Configure the load
sharing mode for the
aggregation group
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
source-ip | source-mac } *
Required
By default, the load
sharing mode of an
aggregation group is the
global load sharing mode.
After you configure this
command, the load
sharing modes in current
link aggregation group
change accordingly.
Displaying and Maintaining Link Aggregation
To do... Use the command... Remarks
Display the local system ID display lacp system-id Available in any view
Display the global or
aggregation group-specific
load sharing mode
display link-aggregation
load-sharing mode [ interface
[ bridge-aggregation
interface-number ] ]
Available in any view
Display link aggregation details
of ports
display link-aggregation
member-port [ interface-type
interface-number [ to interface-type
interface-number ] ]
Available in any view
Display the summary
information of all aggregation
groups
display link-aggregation
summary
Available in any view