3-15
Follow these steps to bind RIP to MIB:
To do… Use the command… Remarks
Enter system view system-view ––
Bind RIP to MIB rip mib-binding process-id
Optional
By default, MIB is bound to RIP process 1.
Configuring the RIP Packet Sending Rate
RIP periodically sends routing information in RIP packets to RIP neighbors.
Sending large numbers of RIP packets at the same time may affect device performance and consume
large network bandwidth. To solve this problem, you can specify the maximum number of RIP packets
that can be sent at the specified interval.
Follow these steps to configure the RIP packet sending rate:
To do… Use the command… Remarks
Enter system view system-view ––
Enable a RIP process and
enter RIP view
rip [ process-id ] ––
Configure the maximum
number of RIP packets that
can be sent at the specified
interval
output-delay time count count
Optional
By default, an interface sends
up to three RIP packets every
20 milliseconds.
Displaying and Maintaining RIP
To do… Use the command… Remarks
Display RIP current status
and configuration information
display rip [ process-id ]
Display all active routes in
RIP database
display rip process-id database
Display RIP interface
information
display rip process-id interface
[ interface-type interface-number ]
Display routing information
about a specified RIP process
display rip process-id route
[ ip-address { mask | mask-length } |
peer ip-address | statistics ]
Available in any view
Clear the statistics of a RIP
process
reset rip process-id statistics Available in user view
RIP Configuration Examples
Configuring RIP Version
Network requirements
As shown in Figure 3-4, enable RIPv2 on all interfaces on Switch A and Switch B.
To Next Page
Loading...
