2-6
Features Description
IGMP Snooping
Running at the data link layer, IGMP Snooping is a multicast control
mechanism on the Layer 2 Ethernet switch and it is used for multicast
group management and control. This document describes:
z Configuring Basic Functions of IGMP Snooping
z Configuring IGMP Snooping Port Functions
z Configuring IGMP Snooping Querier
z Configuring IGMP Snooping Policy
Multicast VLAN Multicast VLAN configuration
MLD Snooping
Multicast Listener Discovery Snooping (MLD Snooping) is an IPv6
multicast constraining mechanism that runs on Layer 2 devices to
manage and control IPv6 multicast groups. This document describes:
z Configuring Basic Functions of MLD Snooping
z Configuring MLD Snooping Port Functions
z Configuring MLD Snooping Querier
z Configuring MLD Snooping Policy
IPv6 Multicast VLAN IPv6 Multicast VLAN configuration
QoS Volume
Table 2-5 Features in the QoS ACL volume
Features Description
QoS Overview
For network traffic, the Quality of Service (QoS) involves bandwidth, delay,
and packet loss rate during traffic forwarding process. This document
describes:
z Introduction to QoS
z Introduction to QoS Service Models
z QoS Techniques Overview
QoS Configuration
Approaches
Two approaches are available for you to configure QoS: policy-based and
non policy-based. This document describes:
z QoS Configuration Approach Overview
z Configuring a QoS Policy
Priority Mapping
The priorities of a packet determine its transmission priority. There are two
types of priority: priorities carried in packets and priorities locally assigned
for scheduling only.
When a packet enters the device from a port, the device assigns a set of
QoS priority parameters to the packet based on a certain priority and
sometimes may modify its priority, according to certain rules depending on
device status. This process is called priority mapping.
Traffic Policing, Traffic
Shaping, and Line
Rate
This document describes:
z Traffic Policing, Traffic Shaping, and Line Rate Overview
z Configuring Traffic Policing
z Configuring GTS
z Configuring the Line Rate