3Com 4510G - Displaying and Maintaining Static Routes; Static Route Configuration Example; Basic Static Route Configuration Example

2-4
Network requirements
To detect the reachability of a static route's nexthop through a Track entry, you need to create a Track
first. For detailed Track configuration procedure, refer to Track Configuration in the System Volume.
Configuration procedure
Follow these steps to detect the reachability of a static route's nexthop through Track:
To do… Use the command… Remarks
Enter system view system-view —
Associate the static
route with a track entry
ip route-static dest-address { mask | mask-length }
next-hop-address track track-entry-number [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
Required
Not
configured by
default
z To configure this feature for an existing static route, simply associate the static route with a track
entry. For a non-existent static route, configure it and associate it with a Track entry.
z If a static route needs route recursion, the associated track entry must monitor the nexthop of the
recursive route instead of that of the static route; otherwise, a valid route may be mistakenly
considered invalid.
Displaying and Maintaining Static Routes
To do… Use the command… Remarks
Display the current
configuration information
display current-configuration
Display the brief information of
the IP routing table
display ip routing-table
Display the detailed
information of the IP routing
table
display ip routing-table verbose
View information of static
routes
display ip routing-table protocol static
[ inactive | verbose ]
Available in
any view
Delete all the static routes delete static-routes all
Available In
system view
Static Route Configuration Example
Basic Static Route Configuration Example
Network requirements
The IP addresses and masks of the switches and hosts are shown in the following figure. Static routes
are required for interconnection between any two hosts.