3-8
To do… Use the command… Remarks
Enter system view system-view ––
Enter interface view
interface interface-type
interface-number
––
Define an inbound
additional routing metric
rip metricin [ route-policy
route-policy-name ] value
Optional
0 by default
Define an outbound
additional routing metric
rip metricout [ route-policy
route-policy-name ] value
Optional
1 by default
Configuring RIPv2 Route Summarization
Route summarization means that subnets in a natural network are summarized into a natural network
that is sent to other networks. This feature can reduce the size of routing tables.
Enabling RIPv2 route automatic summarization
You can disable RIPv2 route automatic summarization if you want to advertise all subnet routes.
Follow these steps to enable RIPv2 route automatic summarization:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view rip [ process-id ] ––
Enable RIPv2 automatic route
summarization
summary
Optional
Enabled by default
Advertising a summary route
You can configure RIPv2 to advertise a summary route on the specified interface.
To do so, use the following commands:
To do… Use the command… Remarks
Enter system view system-view ––
Enter RIP view rip [ process-id ] ––
Disable RIPv2 automatic route
summarization
undo summary
Required
Enabled by default
Return to system view quit —
Enter interface view
interface interface-type
interface-number
—
Advertise a summary route
rip summary-address ip-address
{ mask | mask-length }
Required
To Next Page
Loading...
