1-34
To do… Use the command… Remarks
Specify the unit for data flows or
packets to be sent to a
HWTACACS server
data-flow-format { data
{ byte | giga-byte | kilo-byte
| mega-byte } | packet
{ giga-packet | kilo-packet |
mega-packet |
one-packet } }*
Optional
The defaults are as follows:
byte for data flows, and
one-packet for data packets.
In HWTACACS
scheme view
nas-ip ip-address
quit
Set the source
IP address of
the device to
send
HWTACACS
packets
In system view
hwtacacs nas-ip ip-address
Use either command
By default, the outbound port
serves as the source IP
address to send HWTACACS
packets.
z If a HWTACACS server does not support a username with the domain name, you can configure
the device to remove the domain name before sending the username to the server.
z The nas-ip command in HWTACACS scheme view is only for the current HWTACACS scheme,
while the hwtacacs nas-ip command in system view is for all HWTACACS schemes. However,
the nas-ip command in HWTACACS scheme view overwrites the configuration of the hwtacacs
nas-ip command.
Setting Timers Regarding HWTACACS Servers
Follow these steps to set timers regarding HWTACACS servers:
To do… Use the command… Remarks
Enter system view system-view —
Create a HWTACACS scheme
and enter HWTACACS
scheme view
hwtacacs scheme
hwtacacs-scheme-name
Required
Not defined by default
Set the HWTACACS server
response timeout timer
timer response-timeout
seconds
Optional
5 seconds by default
Set the quiet timer for the
primary server
timer quiet minutes
Optional
5 minutes by default
Set the real-time accounting
interval
timer realtime-accounting
minutes
Optional
12 minutes by default
To Next Page
Loading...
