3Com 4510G - Enabling;Disabling the Display of Copyright Information

9-5
Configuration
System clock displayed by the
display clock command
Example
If date-time is not in the daylight
saving time range, date-time is
displayed.
Configure: clock timezone zone-time add
1, clock summer-time ss one-off 1:00
2008/1/1 1:00 2008/8/8 2 and clock
datetime 1:30 2008/1/1
Display: 23:30:00 zone-time Mon
12/31/2007
[1], 2, 3 and 1 or
[1], 3, 2 and 1
date-time is in the daylight saving
time range:
If the value of
“date-time”-“summer-offset” is not in
the summer-time range,
“date-time”-“summer-offset” is
displayed;
If the value of
“date-time”-“summer-offset” is in the
summer-time range, date-time is
displayed.
Configure: clock timezone zone-time add
1, clock summer-time ss one-off 1:00
2008/1/1 1:00 2008/8/8 2 and clock
datetime 3:00 2008/1/1
Display: 03:00:00 ss Tue 01/01/2008
Enabling/Disabling the Display of Copyright Information
z With the display of copyright information enabled, the copyright information is displayed when a
user logs in through Telnet or SSH, or when a user quits user view after logging in to the device
through the console port, AUX port, or asynchronous serial interface. The copyright information
will not be displayed under other circumstances. The display format of copyright information is as
shown below:
******************************************************************************
* Copyright (c) 2004-2009 3Com Corp. and its licensors. All rights reserved. *
* This software is protected by copyright law and international treaties. *
* Without the prior written permission of 3Com Corporation and its licensors,*
* any reproduction republication, redistribution, decompiling, reverse *
* engineering is strictly prohibited. Any unauthorized use of this software *
* or any portion of it may result in severe civil and criminal penalties, and*
* will be prosecuted to the maximum extent possible under the applicable law.*
******************************************************************************
z With the display of copyright information disabled, under no circumstances will the copyright
information be displayed.
Follow these steps to enable/disable the display of copyright information:
To do… Use the command… Remarks
Enter system view system-view —
Enable the display of copyright
information
copyright-info enable
Optional
Enabled by default.
Disable the display of copyright
information
undo copyright-info enable
Required
Enabled by default.