2-3
Figure 2-4 Set port parameters terminal window
z Turn on the switch. The user will be prompted to press the Enter key if the switch successfully
completes POST (power-on self test). The prompt (such as <4510G>) appears after the user
presses the Enter key.
The username is “admin” and none of the password.
z You can then configure the switch or check the information about the switch by executing
commands. You can also acquire help by type the ? character. Refer to the following chapters for
information about the commands.
Console Port Login Configuration
Common Configuration
Table 2-2 lists the common configuration of Console port login.
Table 2-2 Common configuration of Console port login
Configuration Description
Enter system view system-view —
Enter AUX user interface view user-interface aux 0 —
Console (AUX
user
interface)port
Baud rate speed speed-value
Optional
The default baud rate is 19,200
bps.
To Next Page
Loading...
