3Com 4510G - Configuring an Aggregation Group; Configuring a Static Aggregation Group

2-6
Task Remarks
Enabling LinkUp/LinkDown Trap Generation
for an Aggregate Interface
Optional
Shutting Down an Aggregate Interface Optional
Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Optional
Configuring an Aggregation Group
z The following ports cannot be assigned to an aggregation group: Stack ports, RRPP-enabled
ports, MAC address authentication-enabled ports, port security-enabled ports, IP source
guard-enabled ports, and 802.1x-enabled ports.
z You are recommended not to assign reflector ports of port mirroring to an aggregation group. For
details about reflector ports, refer to Port Mirroring Configuration in the Access Volume.
Configuring a Static Aggregation Group
Follow these steps to configure a Layer 2 static aggregation group:
To do... Use the command... Remarks
Enter system view system-view —
Create a Layer 2
aggregate interface and
enter the Layer 2
aggregate interface
view
interface bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, a Layer 2
static aggregation group
numbered the same is created
automatically.
Exit to system view quit —
Enter Ethernet interface
view
interface interface-type
interface-number
Assign the Ethernet
interface to the
aggregation group
port link-aggregation group number
Required
Repeat the two steps to assign
multiple Ethernet interfaces to
the aggregation group.