3Com 4510G - Page 325

1-4
To do… Use the command… Remarks
Display information about
routes with destination
addresses in the specified
range
display ip routing-table ip-address1
{ mask-length | mask } ip-address2
{ mask-length | mask } [ verbose ]
Available in any
view
Display information about
routes permitted by an IPv4
basic ACL
display ip routing-table acl acl-number
[ verbose ]
Available in any
view
Display routing information
permitted by an IPv4 prefix list
display ip routing-table ip-prefix
ip-prefix-name [ verbose ]
Available in any
view
Display routes of a routing
protocol
display ip routing-table protocol protocol
[ inactive | verbose ]
Available in any
view
Display statistics about the
network routing table
display ip routing-table statistics
Available in any
view
Clear statistics for the routing
table
reset ip routing-table statistics protocol
{ all | protocol }
Available in user
view
Display brief IPv6 routing table
information
display ipv6 routing-table
Available in any
view
Display verbose IPv6 routing
table information
display ipv6 routing-table verbose
Available in any
view
Display routing information for
a specified destination IPv6
address
display ipv6 routing-table ipv6-address
prefix-length [ longer-match ] [ verbose ]
Available in any
view
Display routing information
permitted by an IPv6 ACL
display ipv6 routing-table acl acl6-number
[ verbose ]
Available in any
view
Display routing information
permitted by an IPv6 prefix list
display ipv6 routing-table ipv6-prefix
ipv6-prefix-name [ verbose ]
Available in any
view
Display IPv6 routing
information of a routing
protocol
display ipv6 routing-table protocol protocol
[ inactive | verbose ]
Available in any
view
Display IPv6 routing statistics display ipv6 routing-table statistics
Available in any
view
Display IPv6 routing
information for an IPv6 address
range
display ipv6 routing-table ipv6-address1
prefix-length1 ipv6-address2 prefix-length2
[ verbose ]
Available in any
view
Clear specified IPv6 routing
table statistics
reset ipv6 routing-table statistics protocol
{ all | protocol }
Available in user
view