3Com 4510G - Page 484

To do… Use the command… Remarks
Enter user profile view user-profile profile-name dot1x
Required
The configuration made in
user profile view takes effect
when the user-profile is
activated and there are online
users.
Refer to User Profile
Configuration in the QoS
Volume for more information
about user profiles.
Apply the QoS policy
qos apply policy policy-name
{ inbound | outbound }
Required
Use the inbound keyword to
apply the QoS policy to the
traffic received by the online
users. Use the outbound
keyword to apply the QoS
policy to the traffic sent by the
online users.
Return to system view quit —
Activate the user profile user-profile profile-name enable
Required
Inactive by default
z If a user profile is active, the QoS policy, except ACLs referenced in the QoS policy, applied to it
cannot be configured or removed. If the user profile is being used by online users, the referenced
ACLs cannot be modified either.
z The QoS policies applied in user profile view support only the remark, car, and filter actions.
z Do not apply an empty policy in user profile view because a user profile with an empty policy
applied cannot be activated.
z Refer to User Profile Configuration in the QoS Volume for more information about user profiles.
Applying the QoS policy to a VLAN
You can apply a QoS policy to a VLAN to regulate traffic of the VLAN.
Follow these steps to apply the QoS policy to a VLAN:
To do… Use the command… Remarks
Enter system view system-view —
Apply the QoS policy to VLANs
qos vlan-policy policy-name
vlan vlan-id-list inbound
Required