16-3
Figure 16-2 MIB tree
A
2
6
1
5
2
1
1
2
1
B
SNMP Configuration
As configurations for SNMPv3 differ substantially from those of SNMPv1 and SNMPv2c, their SNMP
functionalities is introduced separately below.
Follow these steps to configure SNMPv3:
To do… Use the command… Remarks
Enter system view system-view —
Enable SNMP agent snmp-agent
Optional
Disabled by default
You can enable SNMP agent
through this command or any
commands that begin with
snmp-agent.
Configure SNMP agent system
information
snmp-agent sys-info
{ contact sys-contact |
location sys-location | version
{ all | { v1 | v2c | v3 }* } }
Optional
The defaults are as follows:
3Com Corporation. for contact,
Marlborough, MA 01752 USA
for location, and SNMP v3 for
the version.
Configure an SNMP agent
group
snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Required
Convert the user-defined plain
text password to a cipher text
password
snmp-agent
calculate-password
plain-password mode { md5 |
sha | 3desmd5 | 3dessha }
{ local-engineid |
specified-engineid engineid }
Optional
Add a new user to an SNMP
agent group
snmp-agent usm-user v3
user-name group-name
[ [ cipher ]
authentication-mode { md5 |
sha } auth-password
[ privacy-mode { 3des |
aes128 | des56 }
priv-password ] ] [ acl
acl-number ]
Required
If the cipher keyword is
specified, the arguments
auth-password and
priv-password are considered
as cipher text password.
To Next Page
Loading...
