136
A
PPENDIX
C: O
PTIONAL
D
IRECT
C
ONNECTION
To do this, connect a cable from the Ethernet port on the
management station to the LAN Port of the Internet
Firewall.
3
Switch on the Internet Firewall.
To do this, connect the power adapter to the port on the
back labeled Power. Do not use a power adapter other
than the one supplied with the Internet Firewall.
4
Wait for the Power LED to stop flashing.This takes
approximately 90 seconds.
5
Follow the initial configuration steps as described in
Chapter 3
.
6
Disconnect the management station from the Internet
Firewall and reconnect it to the main Ethernet network.
In some cases, you may have to restart the management
station after reconnecting it.
7
Attach the Internet Firewall to the LAN (see Chapter 3
) and
continue with configuration.
To Next Page
Loading...