353D Systems, Inc.
12. Rinse the tank and rell it with 0.75 liters of water.
13. Using plastic tongs, place the model back into the tank.
14. Once all of the caustic soda has been cleaned from the area, you may remove your personal protection equipment.
15. Repeat the ultrasonic process with clean water for 30 minutes at 60°C to remove any caustic soda residue that may remain on the
model.
16. Once the ultrasonic process has completed the second time, use plastic tongs to remove the model from the ultrasonic tank.
17. Rinse it under cold water for 1 to 2 minutes.
To Next Page
Loading...
