273D Systems, Inc.
7
PRINTING YOUR CREATION
There are many 3D creations available at www.Cubify.com. In addition, you can create your own with the included Cubify Invent
software. For more information about converting a .stl le into a .cubepro le which the printer can use, refer to the section titled
CubePro Software.
PRINTING PROCEDURE
The following steps illustrate how to print a creation.
1. After powering up your printer and turning on your display, press the
touchscreen to begin.
2. Select PRINT.
NOTE: If the le is saved on a USB mass storage device, insert the
device into the USB port on the printer.
NOTE: You can also print directly from the CubePro software using
a USB cable connecting the printer to the computer or by wireless
connection.
3. Using the arrows, navigate to your le and select PRINT.
NOTE: The le name will be displayed at the top.
NOTE: If the print le requires PLA material and ABS material is
installed, the printer will prompt you to change the cartridge(s).
Select CHANGE CARTRIDGE and refer to the section titled
Replacing A Material Cartridge.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
