3D Systems CubePro - Page 32

283D Systems, Inc.
NOTE: If the print le requires ABS material and PLA material
is installed, the printer will prompt the user to change the
cartridge(s). Select CHANGE CARTRIDGE and refer to the section
titled Replacing A Material Cartridge.
NOTE: If the print le requires ABS material but PLA is installed,
the printer will prompt you to change the material cartridge. Select
CANCEL and follow the instructions in the section titled Replacing
A Material Cartridge.
NOTE: If there is not enough material in the cartridge to complete
the print, the printer will prompt the user to replace the cartridge.
Select CHANGE CARTRIDGE and follow the instructions in the
section titled Replacing A Material Cartridge.
NOTE: If the creation le uses color(s) that are not installed,
selecting the checkmark will enable the printer to change the color
of the print to a color currently installed. You can also change
the cartridge by selecting BACK and following the CHANGE
CARTRIDGE instructions. To change the cartridge, refer to the
section titled Replacing A Material Cartridge.