573D Systems, Inc.
SETTING UP AN AD HOC NETWORK
NOTE: An ad hoc wireless network can not be created in Windows® XP.
An ad hoc network is a temporary yet direct connection between a computer or device and the printer. It does not connect through
a router or base station and the data transfer rates are slower than the transfer rate of standard wireless networks. The computer or
device you wish to connect ad hoc to the printer must have an ad hoc adapter installed. An ad hoc network is deleted when the user
has disconnected from it or is out of range of other devices on the network unless it has been made a permanent network.
1. Select SETUP from the home screen.
2. Using either the left or right the navigation arrows, navigate to the Network
screen.
3. Select WIFI.
4. Select ADHOC from the Select WIFI Connection Type screen.
5. Select the ON/OFF bar to turn on the ad hoc network connection.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
