3D Systems CubePro - Setup and Activate Your Cubepro

143D Systems, Inc.
SETUP AND ACTIVATE YOUR CUBEPRO
1. Select your language. Press the checkmark to conrm your selection.
2. Enter a name for your printer. Scroll to the letters you wish to select by pressing
the arrow symbols on each side of the screen. Press the letters to select them.
Select the checkmark to continue. If you do not wish to name your CubePro,
press SKIP to move to the next screen and continue with step 4.
3. Connect your printer to your wireless network. Use the up or down arrow to scroll
to your network choice. Select the checkmark to continue.
NOTE: If your network is password protected, the printer will rst
prompt you to enter the password.
NOTE: The printer can also connect to an ad hoc network, a
decentralized network that wirelessly connects a local computer
to the printer directly. The computer must have a wireless adapter
congured for ad-hoc mode. The adapter must use the same SSID as
is found in the printer. Connecting to an ad hoc network is discussed
further in the section titled Setting Up an Ad Hoc Network.