293D Systems, Inc.
4. Apply two (2) thin layers of glue to the center of the plate. Select the
checkmark to continue.
NOTE: For more information, refer to the section titled Applying
Cube Glue.
NOTE: For small print le sizes, use a light coating of glue.
If the le size is larger, a slightly thicker coating of glue is
recommended. When the printer begins to print, the glue surface
should be mostly dry. The temperature from the molten plastic will
melt the surface of the glue increasing its adhesion.
NOTE: Ensure that the area where glue is applied is larger than the
base of your creation.
NOTE: The estimated time to completion is noted at the bottom of
the screen.
NOTE: When printing with only ABS material, the print chamber
will need to build and maintain a predetermined temperature.
Ensure the top cover and the back panel have been installed. The
front door must be closed.
NOTE: When printing with PLA only or both PLA and ABS material,
the print chamber will not need to be preheated.
NOTE: The print jets required for the print job will begin to heat.
CAUTION: Do not touch the print jets until they have cooled to
room temperature.
To Next Page
Loading...
