User’s Manual
Enterprise Access Point ENGLISH
Copyright © 4IPNET, INC. All rights reserved.
Please follow the steps mentioned below to install the hardware of EAP727:
Step 1. Place the EAP727 at the best location. The best location is usually at the center of your intended
wireless network.
Wall/Ceiling Mounting
- Place the mounting bracket on a wall or ceiling
- Mark the points where you will insert the screws.
- Drill holes in the marked points and insert the plastic anchors.
- Use the supplied screws to attach the mounting bracket to the wall/ceiling
- Attach the Access Point to the mounting bracket (After Steps 2 and 3)
To Next Page
Loading...
