Operation Manual / 4 Product description / A130-M.. - A145-M..
6 Periodic maintenance work / 6.4 Cleaning components mechanically
© Copyright 2017 ABB. All rights reserved. HZTL4031_EN Revision F August 2017
6.4.3 Compressor-end, non-rotating parts
WARNING
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or con-
tact with them may be harmful to health.
u Do not breathe in these substances and avoid contact with the skin.
u Ensure proper ventilation.
u Observe the information in the material safety data sheet for the operat-
ing materials and supplies.
u Wear personal protective equipment (PPE) according to the material
safety data sheet.
u Comply with local legislation.
Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
The following parts, which are relevant in terms of performance, can be cleaned in accord-
ance with the description below.
Fig.25: Compressor-end, non-rotating parts
72000 Compressor casing
77000 Wall insert
79000 Diffuser
u Steam-clean the above-mentioned components or soak in diesel oil or water with house-
hold cleaning agents. After soaking, remove contamination with a brush.
u Dry components completely.
u Spray cleaned surfaces with penetrating oil. Do not spray exterior surfaces of the tur-
bocharger.
u Dispose of contaminated water and cleaning agents in accordance with the information
in the material safety data sheet.
Page 52 / 111
To Next Page
Loading...
