• The integral solid state short circuit protection of the drive does not provide
branch circuit protection. Branch circuit protection must be provided in
accordance with the National Electrical Code and any additional local codes.
• The drive provides motor overload protection. For adjustments, see the
firmware manual.
Disclaimers
￭
Generic disclaimer
The manufacturer shall have no obligation with respect to any product which (i)
has been improperly repaired or altered; (ii) has been subjected to misuse,
negligence or accident; (iii) has been used in a manner contrary to the
manufacturer’s instructions; or (iv) has failed as a result of ordinary wear and tear.
￭
Cyber security disclaimer
This product is designed to be connected to and to communicate information and
data via a network interface. It is Customer's sole responsibility to provide and
continuously ensure a secure connection between the product and Customer
network or any other network (as the case may be). Customer shall establish and
maintain any appropriate measures (such as but not limited to the installation of
firewalls, application of authentication measures, encryption of data, installation
of anti-virus programs, etc.) to protect the product, the network, its system and
the interface against any kind of security breaches, unauthorized access,
interference, intrusion, leakage and/or theft of data or information.
ABB and its affiliates are not liable for damages and/or losses related to such
security breaches, any unauthorized access, interference, intrusion, leakage and/or
theft of data or information.
182 Technical data
To Next Page
Loading...
