ABB ACH480 - To install the drive to a DIN installation rail

4. Install the mounting screws into the holes. Leave a gap between the screw
head and installation surface.
M1
M2
5. Put the drive onto the mounting screws.
6. Tighten the mounting screws.
5
6
￭
To install the drive to a DIN installation rail
Use an IEC/EN 60715 top hat type installation rail, width × height = 35 × 7.5 mm
(1.4 × 0.3 in).
1. Move the locking part to the left.
42 Mechanical installation
4