DescriptionTerm
Converts direct current and voltage to alternating current and
voltage.
Inverter
A pre-defined set of default values of parameters in a drive control
program.
Macro
In the drive control program, user-adjustable operation instruction
to the drive, or signal measured or calculated by the drive.
In some (for example fieldbus) contexts, a value that can be accessed
as an object. For example, variable, constant, or signal.
Parameter
Programmable logic controllerPLC
Optional blank control panel coverRDUM-01
Converts alternating current and voltage to direct current and voltageRectifier
Radio-frequency interferenceRFI
I/O & EIA-485 moduleRIIO-01
Safety integrity level (1…3) (IEC 61508, IEC 62061, IEC 61800-5-2)SIL
Safe torque off (IEC/EN 61800-5-2)STO
Related manuals
You can find manuals on the Internet. See below for the relevant code/link. For
more documentation, go to www.abb.com/drives/documents.
ACH480 manuals
Introduction to the manual 27
To Next Page
Loading...
