ABB ACQ80-04 - Page 20

20 Start-up, control with I/O and ID run
Refer to the motor nameplate for the following nominal value settings of the motor. Enter the
values exactly
as shown on the motor nameplate.
Example of a nameplate of an induction (asynchronous) motor:
Navigate to Main menu and select Motor data .
Set the motor nominal current:
• Use and to move the cursor left and right.
• Use and to change the value.
Press (OK). to accept the new setting, or press
(Back) to go back to the previous view without making
changes.
Set the torque and motor Cos Φ, if needed. Motor
nominal cos Φ and nominal torque are optional.:
• Use and to move the cursor left and right.
• Use and to change the value.
Press (OK) to accept the new setting, or press
(Back) to go back to the previous view without making
changes.
Set the desired motor control mode. if Vector motor
control is selected, make sure that ID run is performed.
See ID run procedure.
Navigate to Options menu
→ and set the
direction.
M2AA 200 MLA 4
1475
1475
1470
1470
1475
1770
32.5
56
34
59
54
59
0.83
0.83
0.83
0.83
0.83
0.83
3GAA 202 001 - ADA
180
IEC 34-1
6210/C36312/C3
Cat. no
35
30
30
30
30
30
50
50
50
50
50
60
690 Y
400 D
660 Y
380 D
415 D
440 D
V
Hz kW
r/min A cos
IA/IN
t
E/s
Ins.cl. F
IP 55
No
IEC 200 M/L 55
3
motor
ABB Motors
2.20kW
3A
400.0V
Scalar
3.0
96.06
A
0.000Nm
Cos Φ
U V W
0.00
0.000Nm
Cos Φ
U V W
0.00
2.20kW
4.7A
400.0V
Scalar
Loc 10.13.04Hz
13.04
Hz
I
ACQ80 FW.book Page 20 Thursday, February 14, 2019 11:33 AM