Program features 49
Diagnostics
Signal supervision
Six signals can be selected to be supervised by this function. Whenever a supervised
signal exceeds or falls below predefined limits, a bit in 32.01 Supervision status is
activated, and a warning or fault generated.
For example, if user wants to monitor DC voltage and generate a warning/fault
message if it exceeds certain limit, he/she can select DC Voltage [7] in the parameter
32.07 Supervision 1 signal, set low/high limit in the parameter 32.09/32.10 and set
the action in the parameter 32.06 Supervision 1 action.
The supervised signal is low-pass filtered.
Settings
Parameter group 32 Supervision (page 114).
Diagnostics menu
The Diagnostics menu provides quick information about active faults, warnings, fault
history and I/O connection status. It also helps you to find out why the drive is not
starting, stopping or running as desired.
• Active faults : Displays currently active faults. For information on the fault
codes, see list of Fault messages on page 209.
• Fault history : Displays the fault history. For information on the fault codes, see
list of Fault messages on page 209.
• Active warnings : Displays currently active warnings. For information on the
warning codes, see list of Warning messages on page 200.
• I/O status : Displays currently active I/O settings.
Settings
Menu
→ Diagnostics
Load analyzer
Peak value logger
The user can select a signal to be monitored by a peak value logger. The logger
records the peak value of the signal along with the time the peak occurred, as well as
motor current, DC voltage and motor speed at the time of the peak. The peak value is
sampled at 2 ms intervals.
Amplitude loggers
The control program has two amplitude loggers.
ACQ80 FW.book Page 49 Thursday, February 14, 2019 11:33 AM
To Next Page
Loading...
