22 Start-up, control with I/O and ID run
Start, stop, and reference values
If you do not wish to use a macro, navigate to Main menu → Complete parameter list
→ Parameter group 79 and manually define the settings for start, stop and reference.
Notes:
• References can be provided only in local mode. In remote mode, fieldbus speed
reference can be provided only if parameter 79.40 MPPT reference is disabled. When
MPPT reference is enabled in remote mode, drive calculates the speed/frequency
reference internally. For information on MPPT, see section MPPT functionality on page
34.
• Changing the start, stop, and reference settings, changes the I/O signals used in the
drive. You can see the currently used I/O signals in the menu.
• Make sure the used I/O connections match with the actual I/O wiring. See Control
macros on page 55.
Limit settings
Navigate to Main menu → Complete parameter list
→ Parameter group 30
Limits and change the parameters to the required values. For example, maximum speed,
minimum frequency, maximum frequency and maximum current.
After making the changes, press OK to accept or press (Back) to go back to the
previous view without making changes.
3 – I/O menu
After the additional changes, make sure the used I/O connections match with the actual I/O
wiring. See Control macros on page 55.
To see the currently used I/O signals, navigate to Main menu →I/O menu →I/O
status .
Use and to check the values.
4 – Diagnostics menu
After the additional adjustments and I/O connection
validation, navigate to Main menu
→Diagnostics and make sure the setup is
functioning correctly.
The Diagnostics menu shows active faults , fault
history , active warnings , and I/O status .
ACQ80 FW.book Page 22 Thursday, February 14, 2019 11:33 AM
To Next Page
Loading...
