ABB ACS150 - Operation; Select

Control panel
47
Operation
You operate the control panel with the help of menus and keys. You select an option
(e.g. operation mode or parameter) by scrolling the
and arrow keys until
the option is visible in the display and then pressing the key.
With the key, you return to the previous operation level without saving the made
changes.
The ACS150 includes an integrated potentiometer located at the front of the drive. It
is used for setting the frequency reference.
The Integrated Control Panel has six panel modes: Output, Reference, Short
Parameter, Long Parameter, Changed Parameters and Fault. The operation in the
first five modes is described in this chapter. When a fault or alarm occurs, the panel
goes automatically to the Fault mode showing the fault or alarm code. You can reset
the fault or alarm in the Output or Fault mode (see chapter Fault tracing).
When the power is switched on, the panel is in the Output mode, where you can
start, stop, change the direction, switch between local and remote control, monitor
up to three actual values (one at a time) and set the frequency reference. To do other
tasks, go first to the Main menu and select the appropriate mode. The figure below
shows how to move between modes.
LOC
FAULT
FWD
F0007
LOC
MENU FWD
rEF
LOC
MENU FWD
PAr S
LO C
MENU FWD
PAr L
LOC
MENU FWD
PArCh
LOC
Hz
OUTPUT FWD
491
.
Output mode (p. 51)
Reference mode (p. 52)
Short Parameter mode (p. 53)
Long Parameter mode (p. 53)
Changed Parameters mode (p. 53)
Fault mode (p. 105)
After reset the panel returns to
the previous display.
The panel goes automatically
to the Fault mode.
Main menu