ABB ACS150 - How to View and Set the Frequency Reference; Reference Mode; Select

Control panel
52
Reference mode
In the Reference mode, you can:
• view and set the frequency reference
• start, stop, change direction and switch between local and remote control.
How to view and set the frequency reference
You can set the local frequency reference with the integrated potentiometer in any
mode when the drive is in local control if parameter 1109 LOC REF SOURCE has
the default value 0 (POT). If parameter 1109 LOC REF SOURCE has been changed
to 1 (KEYPAD), you have to set the local frequency reference in the Reference
mode.
You can view the current local reference in the Reference mode only.
Step Action Display
1. Go to the Main menu by pressing if you are in the Output mode,
otherwise by pressing repeatedly until you see MENU at the bottom.
2. If the drive is in remote control (REM shown on the left), switch to local
control by pressing . The display briefly shows “LoC” before switching
to local control.
Note: With group 11 REFERENCE SELECT, you can allow changing of the
remote (external) reference in remote control (REM) e.g. using the
integrated potentiometer or keys and .
3. If the panel is not in the Reference mode (“rEF” not visible), press key
or until you see “rEF” and then press . Now the display
shows the current reference value with under the value.
4. If parameter 1109 LOC REF SOURCE = 0 (POT, default):
• To increase the reference value, rotate the integrated potentiometer
clockwise.
• To decrease the reference value, rotate the integrated potentiometer
counterclockwise.
The new value (potentiometer setting) is shown in the display.
If parameter 1109 LOC REF SOURCE = 1 (KEYPAD):
• To increase the reference value, press .
• To decrease the reference value, press .
The new value is shown in the display.
REM
MENU FWD
PAr S
LOC
REM
LOC
MENU FWD
PAr S
SET
LOC
MENU FWD
rEF
LOC
Hz
SET FWD
491
.
LOC
Hz
SET FWD
500
.
LOC
Hz
SET FWD
500
.