ABB ACS880-01 - Connecting the Control Cables; Connection Process

Connecting the control cables
See section Control units of the drive (page 141) for the default I/O connections of the
Factory macro of ACS880 primary control program. For other macros and control
programs, see the firmware manual.
￭ Connection process
This drawing shows an example connection of control cables.
6
5
7
7
1.5 N·m
0.5 N·m
3
3
1.5 N·m
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
108 Electrical installation – IEC