10
Start-up
Contents of this chapter
This chapter describes the start-up procedure of the drive.
Start-up procedure
1. Run setup of the drive control program according to the start-up instructions given
in quick start-up guide for ACS880 primary control program or in the firmware manual.
• For drives with resistor braking (option +D150): see also section Start-up in
chapter Resistor braking.
• For drives with ABB sine filter, check that parameter 95.15 Special HW settings
is set to ABB sine filter. For other sine filters, see Sine filter hardware manual
(3AXD50000016814 [English]).
•
For drives with ABB motors in explosive atmospheres, see also ACS880 drives
with ABB motors in explosive atmospheres (3AXD50000019585 [English]).
2. Validate the Safe torque off function according to the instructions given in chapter
The Safe torque off function.
3.
Validate the safety functions (option +Q973 or +Q972) as described in FSO-12
safety functions module user’s manual (3AXD50000015612 [English]) or in FSO-21
safety functions module user’s manual (3AXD50000015614 [English]).
Start-up 155
To Next Page
Loading...
