Compliance with the EN 61800-3:204 + A1:2012
￭ Definitions
EMC stands for Electromagnetic Compatibility. It is the ability of electrical/electronic
equipment to operate without problems within an electromagnetic environment. Likewise,
the equipment must not disturb or interfere with any other product or system within its
locality.
First environment includes establishments connected to a low-voltage network which
supplies buildings used for domestic purposes.
Second environment includes establishments connected to a network not supplying
domestic premises.
Drive of category C1: drive of rated voltage less than 1000 V and intended for use in
the first environment.
Drive of category C2: drive of rated voltage less than 1000 V and intended to be installed
and started up only by a professional when used in the first environment.
Note: A professional is a person or organization having necessary skills in installing
and/or starting up power drive systems, including their EMC aspects.
Drive of category C3: drive of rated voltage less than 1000 V and intended for use in
the second environment and not intended for use in the first environment.
Drive of category C4: drive of rated voltage equal to or above 1000 V, or rated current
equal to or above 400 A, or intended for use in complex systems in the second
environment.
￭ Category C2
The emission limits are complied with the following provisions:
1. The drive is equipped with EMC filter +E202.
2. The motor and control cables are selected as specified in this manual.
3. The drive is installed according to the instructions given in this manual.
4.
For the maximum motor cable length, see section Motor connection data.
WARNING! The drive may cause radio interference if used in residential or
domestic environment. The user is required to take measures to prevent
interference, in association to the requirements for the CE compliance listed above,
if necessary.
238 Technical data
To Next Page
Loading...
