￭ Frames R5 to R9 (IP21, UL Type 1)
1.
See the dimensions in chapter Dimension drawings. Mark the locations for the four
or six mounting holes.
Note: The lowest holes/mounting screws or bolts are not necessarily needed. If you
use also them, you can replace the drive module without removing the cable entry
box from the wall.
2. Drill the mounting holes.
3. Insert fixings anchors or plugs into the holes. Start the two upper bolts and the two
lowest bolts into the anchors or plugs. Drive the bolts long enough into the wall to
make them carry the weight of the drive.
4. Position the drive module onto the bolts on the wall.
5. Tighten the upper mounting bolts in the wall securely.
6. Remove the front cover.
7. Attach the cable box to the drive frame. For instructions, see the assembly drawing
in the cable box. A view of frame R8 is shown below.
8. Tighten the lower mounting bolts in the wall securely.
Mechanical installation 57
To Next Page
Loading...
