ABB ACS880-01 - High Speed Mode

High speed mode
Selection High speed mode of parameter 95.15 Special HW settings improves control
performance at high output frequencies. ABB recommends it to be selected with output
frequency of 120 Hz and above.
This table gives the drive ratings for the maximum output frequency when High speed
mode in parameter 95.15 Special HW settings is enabled: With output frequencies
smaller than this recommended maximum output frequency, the current derating is less
than the values given in the table. Contact ABB for operation above the recommended
maximum output frequency or for the output current derating with output frequencies
above 120 Hz and below the maximum output frequency.
At the output frequency 120 Hz no derating.
Output ratings with selection High speed mode of parameter 95.15 Special
HW settings
ACS880-01-…
Maximum output frequency
Heavy-duty useLight-duty useNominal usef
max
I
Hd
I
Ld
I
N
AAAHz
U
n
= 230 V
3.33.94.150004A6-2
4.15.65.950006A6-2
5.96.46.750007A5-2
6.79.09.550010A6-2
9.514.315.050016A8-2
15.020.922.050024A3-2
22.028.530.0500031A-2
30.039.041.0500046A-2
415356500061A-2
475356500075A-2
566467500087A-2
678084500115A-2
84101106500145A-2
106128135500170A-2
135157165500206A-2
165180189500274A-2
U
n
= 400 V
1.72.12.250002A4-3
2.22.93.050003A3-3
3.03.43.650004A0-3
3.64.85.050005A6-3
5.06.26.550007A2-3
Technical data 193